Captek™

Captek™

Ceramic fused to a 22k Captek substructure produces esthetics that rival all ceramic restorations. Captek has been proven to reduce harmful bacteria and plaque deposits by as much as 71%, resulting in incredible compatibility with surrounding tissue. In fact, Captek™ has been shown to exhibit less bacterial accumulation than natural teeth in the same mouth!

The Captek™ substructure is not cast, but pressed utilizing the APP SYSTEM. This allows Arcari technicians to create each coping in a precise and consistent manner. Captek provides a warm, lifelike appearance at the gingival margin.

Captek™ from Arcari will give your patients a natural, beautiful smile with greater confidence.

Send In Your Case

Download Rx Form

Indications

Captek™ can be used for all single unit crowns and bridges with up to 2 pontics. Captek™ can be used when reduction of the tooth may be limited. Captek can be used when periodontal health is a concern and when biocompatibility is a concern.

Contraindications

Captek™ should not be used when a tooth preparation is not built back up to preparation form or there is over 3 millimeters of clearance. Captek should not be used when adapting to a future or existing partial, or when a metal occlusal is prescribed.

Preparation

The ideal preparation for PFMs is a chamfer margin preparation. If a porcelain labial margin is prescribed, then a shoulder margin preparation of 1.25 mm is required.

Anterior: 2 mm incisal reduction, 1.5 mm middle third reduction, ensuring preparation is cut into three planes and that labial and lingual walls are convergent.

Posterior: 2 mm occlusal reduction; 1.5 mm middle third reduction; 1.25 mm gingival reduction on the buccal; buccal and lingual walls must be convergent. Feather-edge margin preparations are indicated for full-cast restorations.

Cementation

  • Panavia 21 (Must be tinplated)
  • Glass ionomer cement (GC Fuji, GC America)
  • Zinc Phosphate
  • Polycarboxylate
  • Resin Ionomer cement (RelyX, 3M ESPE)

Tech Notes

We use capillary attraction forces to create the Captek copings. It is the only way to combine the hard, thermally stable particles of platinum/palladium and the resilient, vibration absorbing, esthetic enhancing particles of the high purity gold without sacrificing strength. If we were to take gold, platinum and palladium in similar amounts and melt them together similar to traditional casting methods we would have a soft, weak, silver unstable coping. Just like the way the water and sponge exist, the gold and platinum/palladium exist. We have created an “alloy composite”. Captek is strong (in a sense reinforced), high gold and high temperature stable for accurate margins during porcelain firings.

If an adjustment is required on the ceramic, use a fine diamond with water and air to keep the crown cool. To contour the ceramic, polish with a pink rubber wheel and diamond polishing paste (Brasseler, Shofu, Vident).

Codes

  • D2750 Single Crown PFG
  • D6999 Captek Inlays